2 of my screws that hold on covers on bottom are rounded out any suggestions on how to remove without damage to carbs? my motor will not run after 7000 rpm i think its flooding any suggestions?
| Author | Comment | ||
|---|---|---|---|
 LANGLEY MOTORSPORTZ |
help with keihin 39 fcr carbs |
Lead | |
|
Posts: 114 (03/29/08 10:19 PM) |
|
||
|
CHUCK |
|||
|
Posts: 427 (03/30/08 02:30 AM) |
IF YOU ARWE TALKING ABOUT THE PHILLIPS SCREWS IN THE FLOAT BOWLS I'VE A SMALL PAIR OF CHANNEL LOCKS AND LOOSWN THEM, THEN REPLACED THEM ALLEN BOLTS
I'VE ALSO HAD SOME SUGGESS WITH A "HANDY GRINDER" CUTTIN SLOT IN THE HEAD AND USIND FLAT BLADE SCREW DRIVER
|
||
|
95Fundevil |
|||
|
Posts: 430 (03/30/08 08:42 PM) |
pick up a left handed drill bit run it in reverse as it digs in it will spin the screw backwards. I use this method on big shoulder bolts on trenchers. ACE
hardware carries lefthanders.
Rat 95
Desert Dwarf Car Club Phx, AZ http://eteamz.active.com/fundevilracing/ |
||
