I have a toyota 8 bolt rear end,but the stock corolla gear set will not fit into the housing.the housing on my car is to big.The outside diameter of the
housing is 8 1/4 ".The driveshaft(nose cone) flange to the flange of the rear end is 1" longer then the stock 8 bolt.The axels are toyota as they
will fit into the corolla gear set.Any info. would be great.The gear set that i have in the car are stamped right on the crown 37:10 (3:70) like the 10 bolts.
0 Kudo
toyota rear end help
| Author | Comment | ||
|---|---|---|---|
 caji1 |
toyota rear end help |
Lead | |
|
Posts: 11 (05/03/08 05:24 PM) |
|
||
|
dwarfracingfan |
|||
|
Posts: 7 (05/04/08 06:12 PM) |
I was told mine had a Toyota but it is a Datson
|
||
|
caji1 |
|||
|
Posts: 12 (05/05/08 12:31 AM) |
It's not a Datsun,as my axles fit into another set of toyota gears.Datsun axles have much smaller splines.I was told that maybe older toyota truck
rearends,with an 8 bolt.I think it might be rare.
|
||
|
jbark51 |
Just a thought | ||
|
Posts: 911 (05/05/08 12:32 AM) |
It might just be a mistype in the original post. But will a Toyota "Corolla" rear fit? Isnt the dwarfcar standard a "Corona". They might
even be the same thing. But call Spence at http://www.dwarfcarproducts.com/.
He will know right off the top of his head. JB |
||
|
caji1 |
|||
|
Posts: 14 (05/06/08 12:37 AM) |
I went to put a toyota corolla gear set in the car and the housing was to big.only one of the 8 bolts were lining up.Corolla and corona are both the same.
|
||
